Lithgow-Bertelloni Carolina

No Thumbnail Available
Last Name
Lithgow-Bertelloni
First Name
Carolina
ORCID

Filters

2015 - 2016 2
1 1
2
Reset filters

Settings

Search Results

Now showing 1 - 2 of 2
  • Article
    Temperature and velocity measurements of a rising thermal plume
    (John Wiley & Sons, 2015-03-04) Cagney, Neil ; Newsome, William H. ; Lithgow-Bertelloni, Carolina ; Cotel, Aline ; Hart, Stanley R. ; Whitehead, John A.
    The three-dimensional velocity and temperature fields surrounding an isolated thermal plume in a fluid with temperature-dependent viscosity are measured using Particle-Image Velocimetry and thermochromatic liquid crystals, respectively. The experimental conditions are relevant to a plume rising through the mantle. It is shown that while the velocity and the isotherm surrounding the plume can be used to visualize the plume, they do not reveal the finer details of its structure. However, by computing the Finite-Time Lyapunov Exponent fields from the velocity measurements, the material lines of the flow can be found, which clearly identify the shape of the plume head and characterize the behavior of the flow along the plume stem. It is shown that the vast majority of the material in the plume head has undergone significant stretching and originates from a wide region very low in the fluid domain, which is proposed as a contributing factor to the small-scale isotopic variability observed in ocean-island basalt regions. Lastly, the Finite-Time Lyapunov Exponent fields are used to calculate the steady state rise velocity of the thermal plume, which is found to scale linearly with the Rayleigh number, in contrast to some previous work. The possible cause and the significance of these conflicting results are discussed, and it is suggested that the scaling relationship may be affected by the temperature-dependence of the fluid viscosity in the current work.
  • Preprint
    Constraining the source of mantle plumes
    ( 2016-01-08) Cagney, Neil ; Crameri, Fabio ; Newsome, William H. ; Lithgow-Bertelloni, Carolina ; Cotel, Aline ; Hart, Stanley R. ; Whitehead, John A.
    In order to link the geochemical signature of hot spot basalts to Earth’s deep interior, it is first necessary to understand how plumes sample different regions of the mantle. Here, we investigate the relative amounts of deep and shallow mantle material that are entrained by an ascending plume and constrain its source region. The plumes are generated in a viscous syrup using an isolated heater for a range of Rayleigh numbers. The velocity fields are measured using stereoscopic Particle-Image Velocimetry, and the concept of the ‘vortex ring bubble’ is used to provide an objective definition of the plume geometry. Using this plume geometry, the plume composition can be analysed in terms of the proportion of material that has been entrained from different depths. We show that the plume composition can be well described using a simple empirical relationship, which depends only on a single parameter, the sampling coefficient, Sc. High-Sc plumes are composed of material which originated from very deep in the fluid domain, while low-Sc plumes contain material entrained from a range of depths. The analysis is also used to show that the geometry of the plume can be described using a similarity solution, in agreement with previous studies. Finally, numerical simulations are used to vary both the Rayleigh number and viscosity contrast independently. The simulations allow us to predict the value of the sampling coefficient for mantle plumes; we find that as a plume reaches the lithosphere, 90% of its composition has been derived from the lowermost 260−750 km in the mantle, and negligible amounts are derived from the shallow half of the lower mantle. This result implies that isotope geochemistry cannot provide direct information about this un-sampled region, and that the various known geochemical reservoirs must lie in the deepest few hundred kilometres of the mantle.