McCollom Thomas M.

No Thumbnail Available
Last Name
McCollom
First Name
Thomas M.
ORCID

Search Results

Now showing 1 - 4 of 4
  • Article
    Hydrogen generation and iron partitioning during experimental serpentinization of an olivine-pyroxene mixture
    (Elsevier, 2020-05-26) McCollom, Thomas M. ; Klein, Frieder ; Moskowitz, Bruce ; Berquo, Thelma S. ; Bach, Wolfgang ; Templeton, Alexis S.
    A series of laboratory experiments was conducted to investigate serpentinization of olivine–pyroxene mixtures at 230 °C, with the objective of evaluating the effect of mixed compositions on Fe partitioning among product minerals, H2 generation, and reaction rates. An initial experiment reacted a mixture of 86 wt.% olivine and 14 wt.% orthopyroxene (Opx) with the same initial grain size for 387 days. The experiment resulted in extensive reaction (∼53% conversion), and solids recovered at termination of the experiment were dominated by Fe-bearing chrysotile and relict olivine along with minor brucite and magnetite. Only limited amounts of H2 were generated during the first ∼100 days of the experiment, but the rate of H2 generation then increased sharply coincident with an increase in pH from mildly alkaline to strongly alkaline conditions. Two shorter term experiments with the same reactants (26 and 113 days) produced a mixture of lizardite and talc that formed a thin coating on relict olivine and Opx grains, with virtually no generation of H2. Comparison of the results with reaction path models indicates that the Opx reacted about two times faster than olivine, which contrasts with some previous studies that suggested olivine should react more rapidly than Opx at the experimental conditions. The models also indicate that the long-term experiment transitioned from producing serpentine ± talc early in the early stages to precipitation of serpentine plus magnetite, with brucite beginning to precipitate only late in the experiment as Opx was depleted. The results indicate that overall reaction of olivine and Opx was initially relatively slow, but reaction rates accelerated substantially when the pH transitioned to strongly alkaline conditions. Serpentine and brucite precipitated from the olivine-Opx mixture had higher Fe contents than observed in olivine-only experiments at mildly alkaline pH, but had comparable Fe contents to reaction of olivine at strongly alkaline pH implying that higher pH may favor greater partitioning of Fe into serpentine and brucite and less into magnetite. Despite the presence of brucite, dissolved silica activities during the long-term olivine-Opx experiment maintained levels well above serpentine-brucite equilibrium. Instead, silica activities converged on levels close to metastable equilibrium between brucite and olivine. It is proposed that silica levels during the experiment may have been regulated by exchange of SiO2 between the fluid and a silica-depleted, brucite-like surface layer on dissolving olivine.
  • Article
    The effect of pH on rates of reaction and hydrogen generation during serpentinization
    (The Royal Society, 2020-01-06) McCollom, Thomas M. ; Klein, Frieder ; Solheid, Peter ; Moskowitz, Bruce
    A series of three laboratory experiments were conducted to investigate how pH affects reaction pathways and rates during serpentinization. Two experiments were conducted under strongly alkaline conditions using olivine as reactant at 200 and 230°C, and the results were compared with previous studies performed using the same reactants and methods at more neutral pH. For both experiments, higher pH resulted in more rapid serpentinization of the olivine and generation of larger amounts of H2 for comparable reaction times. Proportionally greater amounts of Fe were partitioned into brucite and chrysotile and less into magnetite in the experiments conducted at higher pH. In a third experiment, alkaline fluids were injected into an ongoing experiment containing olivine and orthopyroxene to raise the pH from circumneutral to strongly alkaline conditions. Increasing the pH of the olivine-orthopyroxene experiment resulted in an immediate and steep increase in H2 production, and led to far more extensive reaction of the primary minerals compared to a similar experiment conducted under more neutral conditions. The results suggest that the development of strongly alkaline conditions in actively serpentinizing systems promotes increased rates of reaction and H2 production, enhancing the flux of H2 available to support biological activity in these environments.
  • Preprint
    From serpentinization to carbonation : new insights from a CO2 injection experiment
    ( 2013-08) Klein, Frieder ; McCollom, Thomas M.
    We injected a CO2-rich hydrous fluid of seawater chlorinity into an ongoing, mildly reducing (H2(aq) ≈ 3 mmol/kg) serpentinization experiment at 230°C and 35 MPa to examine the changes in fluid chemistry and mineralogy during mineral carbonation. The chemistry of 11 fluid samples was measured, speciated, and compared with MgO-SiO2-H2O-CO2 (MSHC) phase equilibria to approximate the reaction pathway from serpentinization to carbonation. Although the overall system was in apparent disequilibrium, the speciated activities of dissolved silica (aSiO2(aq)) and carbon dioxide (aCO2(aq)) evolved roughly along MSHC equilibrium phase boundaries, indicative of 4 distinct mineral assemblages over time: 1) serpentine22 brucite (± magnesite) before the injection, to 2) serpentine-talc-magnesite 2 hours after the injection, to 3) quartz-magnesite (48h after injection), and 4) metastable olivine – magnesite (623h after injection) until the experiment was terminated. Inspection of the solid reaction products revealed the presence of serpentine, magnesite, minor talc, and magnetite, in addition to relict olivine. Although quartz was saturated over a short segment of the experiment, it was not found in the solid reaction products. A marked and rapid change in fluid chemistry suggests that serpentinization ceased and precipitation of magnesite initiated immediately after the injection. A sharp decrease in pH after the injection promoted the dissolution of brucite and olivine, which liberated SiO2(aq) and dissolved Mg. Dissolved Mg was efficiently removed from the solution via magnesite precipitation, whereas the formation of talc was relatively sluggish. This process accounts for an increase in aSiO2(aq) to quartz saturation shortly after the injection of the CO2-rich fluid. Molecular dihydrogen (H2(aq)) was generated during serpentinization of olivine by oxidation of ferrous iron before the injection; however, no additional H2(aq) was generated after the injection. Speciation calculations suggest a strong affinity for the formation of methane (CH4(aq)) at the expense of CO2(aq) and H2(aq) after the injection, but increased CH4(aq) formation was not observed. These findings suggest that kinetically fast mineral carbonation dominates over sluggish CH4(aq) formation in mildly reducing serpentinization systems affected by injection of CO2-rich fluids.
  • Preprint
    Experimental constraints on fluid-rock reactions during incipient serpentinization of harzburgite
    ( 2014-10-20) Klein, Frieder ; Grozeva, Niya G. ; Seewald, Jeffrey S. ; McCollom, Thomas M. ; Humphris, Susan E. ; Moskowitz, Bruce ; Berquo, Thelma S. ; Kahl, Wolf-Achim
    The exposure of mantle peridotite to water at crustal levels leads to a cascade of interconnected dissolution-precipitation and reduction-oxidation reactions—a process referred to as serpentinization. These reactions have major implications for microbial life through the provision of hydrogen (H2). To simulate incipient serpentinization under well-constrained conditions, we reacted centimeter-sized pieces of uncrushed harzburgite with chemically modified seawater at 300 ºC and 35 MPa for ca. 1.5 yr (13 441 h), monitored changes in fluid chemistry over time, and examined the secondary mineralogy at the termination of the experiment. Approximately 4 mol% of the protolith underwent alteration forming serpentine, accessory magnetite, chlorite, and traces of calcite and heazlewoodite. Alteration textures bear remarkable similarities to those found in partially serpentinized abyssal peridotites. Neither brucite nor talc precipitated during the experiment. Given that the starting material contained ~4 times more olivine than orthopyroxene on a molar basis, mass balance requires that dissolution of orthopyroxene was significantly faster than dissolution of olivine. Coupled mass transfer of dissolved Si, Mg, and H+ between olivine and orthopyroxene reaction fronts was driven by steep activity gradients and facilitated the precipitation of serpentine. Hydrogen was released in significant amounts throughout the entire experiment; however, the H2 release rate decreased with time. Serpentinization consumed water but did not release significant amounts of dissolved species (other than H2) suggesting that incipient hydration reactions involved a volume increase of ~40%. The reduced access of water to fresh olivine surfaces due to filling of fractures and coating of primary minerals with alteration products led to decreased rates of serpentinization and H2 release. While this concept might seem at odds with completely serpentinized seafloor peridotites, reaction-driven fracturing offers an intriguing solution to the seemingly self-limiting nature of serpentinization. Indeed, the reacted sample revealed several textural features diagnostic of incipient reaction-driven fracturing. We conclude that fracturing must have far reaching impacts on the rates of serpentinization and H2 release in peridotite-hosted hydrothermal systems.