Now showing items 1-10 of 26
Bottom array specifications for the low frequency acoustic seismic experiment (LFASE)
(Woods Hole Oceanographic Institution, 1991-10)
The Low Frequency Acoustic Seismic Experiment (LFASE) was conducted to measure sound propagation and ambient noise above, at and below the sea floor. To this end an array consisting of four geophone nodes was introduced ...
Seafloor borehole array seismic system (SEABASS)
(Woods Hole Oceanographic Institution, 1993-01)
The Seafloor Borehole Array Seismic System (SEABASS) has been developed to measure the pressure and three dimensional particle velocity of the VLF sound field (2-50HZ) below the seafloor in the deep ocean (water depths ...
AFRAME : a video animation capability for displaying FINDIF numerical model output
(Woods Hole Oceanographic Institution, 1995-07)
This report describes the development of a facility for recording time-varying computer graphics on video tape. The primary purpose of the facility is to produce animation sequences of ocean and seafloor acoustic wave ...
Ambient noise analysis and finite difference modelling of VLF borehole seismic data
(Woods Hole Oceanographic Institution, 1987-03)
This report describes a preliminary analysis of borehole seismic data to determine VLF/Sub-bottom Seismic Noise in the Atlantic and the preliminary results of finite difference modelling for a Cape Fear environment. Noise ...
Progress report on the development of the seafloor borehole array seismic system (phase II) : July 14, 1992 to January 31, 1996
(Woods Hole Oceanographic Institution, 1996-06)
The Seafloor Borehole Array Seismic System (SEABASS) was originally developed to record autonomously on the seafloor the signals received on a four-sonde three-component borehole geophone array in the VLF band (2-50Hz)(Stephen ...
Handbook of oceanographic engineering materials : volume I - metals and alloys
(Woods Hole Oceanographic Institution, 1972-12)
This handbook is intended to serve as an aid in materials selection to Oceanographic engineers and designers. As such it is intentionally limited to materials that may be used advantageously in the marine environment.
Late Cenozoic geology of the Central Persian (Arabian) Gulf from industry well data and seismic profiles
(Woods Hole Oceanographic Institution, 1988-04)
Industry seismic reflection profiles shot in the 60's and early 70's in the central Persian (Arabian) Gulf are used to map two late Tertiary unconformities, and velocity data from a centrally located well is used to ...
The marine disposal of sewage sludge and dredge spoil in the waters of the New York Bight
(Woods Hole Oceanographic Institution, 1971-01-29)
The dumping of sewer sludge and dredge spoil in the waters of the New York Bight and the effect of this waste disposal practice on the marine environment is reviewed. The. quantities and composition of these wastes is ...
Tests of propellers for Alvin side propulsion units
(Woods Hole Oceanographic Institution, 1967-07)
Full scale dynamometer tests were run on a series of unshrouded propellers in the range of propeller diameters considered practical for use on the side propulsion units of the research submarine ALVIN. Measurements taken ...
Twenty-four (24) man-hour test of Alvin's environmental system
(Woods Hole Oceanographic Institution, 1964-11)
ALVIN's specifications call for a 48 man-hour environmental system capability. To check this, a 24 man-hour test was run as follows: Two successive test periods of six (6) hours each with a two (2) man crew inside the ...