Auxiliary material for Paper 2003TC001559R Thermochronology of the Modern Indus River Bedload: New insight into the Controls on the Marine Stratigraphic Record Peter D. Clift1, Ian H. Campbell2, Malcolm S. Pringle3,4, Andrew Carter5, Xifan Zhang6, Kip V. Hodges3, Ali Athar Khan7 and Charlotte M. Allen2 1 Department of Geology and Geophysics, Woods Hole Oceanographic Institution, Woods Hole, Massachusetts, USA 2 Institute of Advanced Studies, Research School of Earth Sciences, The Australian National University, Canberra, A.C.T. 0200, Australia 3 Department of Earth, Atmospheric and Planetary Sciences, Massachusetts Institute of Technology, Cambridge, Massachusetts, USA 4 Scottish Universities Environmental Research Centre, Rankine Avenue, East Kilbride, G75 0QF, UK 5 School of Earth Sciences, University and Birkbeck College London, Gower Street, London, WC1E 6BT, UK 6 Department of Geology and Geophysics, University of Wisconsin-Madison, 1215 Dayton Street, Madison, Wisconsin 53706, USA 7 Department of Geology, University of Karachi, Karachi-75270, Pakistan Tectonics DOI (10.1029/2003TC001559R Introduction The auxiliary material for Paper 2003TC001559R comprises five tables with the raw analytical output from the laser fusion analyses performed at the Massachusetts Institute of Technology (MIT). Prior to analysis, samples were irradiated in the C5 position of the McMaster University Nuclear Reactor for 10 hours with a total power of 20 MW. After fusion with an Ar-ion laser, the released gases were purified for 10 minutes with Al-Zr and Fe-Zr-V getters and then admitted to an MAP 215-50 mass spectrometer for Ar isotopic analysis using an electronic multiplier. The final data reduction was conducted with the program ArArCalc [Koppers, 2002]. The conversion efficiency of 39K to 39Ar was monitored using sanidine from the Taylor Creek rhyolite (TCR-2) with an assumed age of 28.34 Ma [Renne et al., 1998]. Corrections for neutron-induced interference were made by the factors previously determined at MIT using K2SO4 and CaF2 salts. Each table includes the raw analytical data, as well as the calculations performed to derive the ages use in the paper. Table 2A.txt Analytical results and age calculations for analyses performed on batches of 10 biotite crystals. Table 2B.txt Analytical results and age calculations for analyses performed on single black biotite grains. Table 2C.txt Analytical results and age calculations for analyses performed on single brown biotite. Table 2D.txt Analytical results and age calculations for analyses performed on single muscovite crystals. Table 2E.txt Analytical results and age calculations for analyses performed on batches of 10 muscovite crystals.